Carrier C708 - Models C708;C709;C716;C717

14
Introduction
Models C708/C709/C716/C717
Power Switch
When placed in the ON position, the power switch
allows control panel operation.
Fluorescent Display
The fluorescent display is located on the front
control panel. During normal operation the display is
blank. The display is used to show menu options
and notifies the operator if a fault is detected. On
International models, the display will indicate the
temperature of the mix in each hopper.
Indicator Lights
MIX LOW - When the MIX LOW symbol is
illuminated, the mix hopper has a low supply of mix
and should be refilled as soon as possible.
MIX OUT - When the MIX OUT symbol is
illuminated, the mix hopper has been almost
completely exhausted and has an insufficient supply
of mix to operate the freezer. At this time, the AUTO
mode is locked out and the freezer will be placed in
the STANDBY mode. To initiate the refrigeration
system, add mix to the mix hopper and touch the
AUTO symbol. The freezer will automatically begin
operation.
HEAT MODE - When the HEAT MODE symbol is
illuminated, the freezer is in the process of a heat
cycle.
BRUSH CLEAN COUNTER - When the BRUSH
CLEAN COUNTER display has counted down to “1”,
the machine must be disassembled and brush
cleaned within 24 hours.
Adjustable Draw Handle
This unit features an adjustable draw handle(s) to
provide the best portion control, giving a better,
consistent quality to your product and controlling
food costs. The draw handle should be adjusted to
provide a flow rate of 5 to 7-1/2 oz (142 to 213 g) of
product by weight per 10 seconds. To INCREASE
the flow rate, turn the screw CLOCKWISE, and
COUNTERCLOCKWISE t o DECREASE the flow
rate. (See Figure 12.)
+
-
10354
Figure 12
Beater Moto r Overload
C708/C709: The beater motor overload is located in
the service panel on the left side.
C716/C717: The beater motor overloads are located
in the rear panel.
The overload protects the beater motor from an
overload condition. Should an overload occur, the
reset mechanism will trip. To properly reset the
freezer, place the power switch in the OFF position.
Press the reset button firmly. Turn the power switch
to the ON position. Touch the WASH symbol and
observe the freezer’s performance.
W ARNING: Do not use metal objects to
press the reset button. Failure to comply may result
in severe personal injury or death from electrical
shock.
If the beater motor is turning properly, touch the
WASH symbol to cancel the cycle. Touch the AUTO
symbol to resume normal operation. If the freezer
shuts down again, contact your authorized service
technician.