EasyManua.ls Logo

Case 845B VHP - Fluid Levels

Case 845B VHP
208 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER 6 – LUBRICATION / FILTERS / FLUIDS
6-9
Engine Crankcase
Check oil level shortly after engine is warm and has been
stopped. Remove the engine oil dipstick (2), and check oil
level. If the oil level is below the minimum mark or above
the maximum mark, do not operate the engine. Add oil if
necessary through the ller neck (1).
ENGINE STOPPED HOT COLD
1
2
ENGINE OIL FILLER 1.
ENGINE OIL DIPSTICK2.
FLUID LEVELS
Each 10 hours or daily services
Radiator
WARNING: Fluid under pressure. Turn the
expansion tank cap slowly to relieve pressu-
re before removing or until the pressure has
been relieved. The coolant may boil over and
cause personal injury.
329044A1
HOT LIQUID UNDER
PRESSURE HAZARD
Service when cool.
WARNING
Engine Coolant Level
Check coolant when engine is cold. Make sure coolant is
visible in sight glass on the expansion tank. If necessary,
add coolant to the expansion tank. Turn the expansion
tank cap slowly to remove pressure. For additional infor-
mation, refer to “Engine Cooling System” on page 6-22.
NOTE: Never add only anti freeze to cooling system wi-
thout checking existing level of protection. Add coolant as
necessary to bring it to the proper level. Tighten expan-
sion tank cap.

Table of Contents

Other manuals for Case 845B VHP

Related product manuals