CHAPTER 2 – SAFETY / DECALS / HAND SIGNALS
2-16
SAFETY DECALS
WARNING: Injury or death can result if you cannot read a safety decal or if a safety decal is missing. Re-
place any missing or damaged safety decal and keep all safety decals clean. See your CASE dealer for
new safety decals.
Make sure that you read all the safety decals and all instructional decals. Check these decals every day before you
start. Clean these decals if you cannot read the words.
When you clean the decals, use only a cloth, water, and soap. Do not use solvent, gasoline, etc.
You must replace a decal if the decal is damaged, missing, or cannot be read. If a decal is on a part that is replaced,
make sure the decal is on the new part. See your CASE dealer for new decals.
Interior Cab View
6
7
15
6
WA RNING
321-7030
USE
SEAT
BEL T
A V OID CRUSHING
DO NOT JUMP
IF MACHINE TIPS
7
ENGINE STARTING INSTRUCTIONS
TO START TURN KEY SWITCH UNTIL ENGINE STARTS.
IF ENGINE DOES NOT START IN 30 SECONDS, ALLOW
STARTER TO COOL FOR 2 MINUTES BEFORE ANOTHER
STARTING ATTEMPT.
COLD ENGINE
START ENGINE A T LOW IDLE OR ONE-FOURTH THROTTLE.
INCREASE ENGINE SPEED TO O NE-HALF THROTTLE UNTIL
COOLANT TEMPERATURE GAUGE NEEDLE MOVES FROM
ITS MINIMUM POSITION. WORK ENGINE WITH NO MORE
THAN ONE-HALF LOAD UNTIL NORMAL COOLANT
TEMPERATURE IS REACHED.
WARM ENGINE
START ENGINE WITH APPROXIMA T ELY ONE-FOURTH
THROTTLE.
ENGINE SHUT-DOWN INSTRUCTIONS
ALLOW TO RUN FOR 3 TO 4 MINUTES A T ONE-FOURTH
THROTTLE BEFORE SHUT-DOWN THE SWITCH KEY.
75325000
15
WARNING
PRESSURIZED SYSTEM
HAZARD
Relieve pressure
before maintenance.
75325025
To Next Page
Loading...
