CHAPTER 7 – MAINTENANCE AND ADJUSTMENT
7-5
1
2
73-87 NM (54-64 FT LB)1. 54-61 NM (40-45 FT LB)2.
Remove dust and dirt from the seat with a vacuum clea-
ner or soft brush. Clean stains with the correct use of a
material cleaner.
Before removing stains, try to nd what type and how old
the stains are. Some stains can be removed with water or
soap solution.
CLEANER FLUID – This type of cleaner can be used for
grease or oil stains. Carefully remove the item that cau-
sed the stain with a scraper or a knife that is not sharp.
Use very little cleaner, no pressure, and clean cloths.
Move the cloth from the outside of the stain toward the
center of the stain and constantly change to a clean sec-
tion of cloth.
Operators Seat
TORQUE SPECIFICATIONS FOR
SEAT AND SEAT BELTS
When the stain is removed from the material, immediate-
ly use a cloth dry the area and to prevent a cleaner cir-
cle pattern. If a circle pattern occurs, clean the complete
area.
NOTE: A difcult stain may need a second application
of cleaner uid followed immediately by the use of a soft
brush to completely remove the stain.
WARNING: Never use gasoline, naphta or
any other volatile material for any cleaning
purposes. These materials may be toxic and
/ or ammable.
To Next Page
Loading...
