Case 845B VHP - Additional Safety Rules

CHAPTER 2 – SAFETY / DECALS / HAND SIGNALS
2-5
Neutral Start and Reverse Warning Checks
IMPORTANT: Perform these checks before operating machine.
ADDITIONAL SAFETY RULES
NEUTRAL START CIRCUIT CHECK
Be sure the area around machine is clear of personnel. •
Disengage the parking brake. •
Completely depress the inching control pedal (only for •
845B, 865B and 885B models with FUNK transmis-
sion).
Move transmission control lever to the forward position. •
The starting motor must not run. •
O motor de partida NÃO DEVE funcionar. •
Move the transmission control lever to the reverse po- •
sition.
Turn the key switch to START. •
The starting motor must not run. •
IMPORTANTE:
Move the transmission control lever to the reverse po-1.
sition.
Engage the parking brake. •
Turn the key switch to START. •
The starting motor should run. •
Move the transmission control lever to the neutral po-2.
sition.
Engage the parking brake. •
Turn the key switch to START. •
The starting motor should run. •
Move the transmission control lever to the forward po-3.
sition.
Engage the parking brake. •
Turn the key switch to START. •
The starting motor should run. •
REVERSE WARNING ALARM CHECK
Be sure area around machine is clear of personnel. •
Engage the parking brake. •
Completely depress the inching control pedal (only for •
845B, 865B and 885B models with FUNK transmis-
sion).
Move transmission control lever to 1st gear in Reverse. •
The reverse warning alarm must sound. •
For more information, see “Inching Control Pedal”, “Trans-
mission Control Lever”, “Ignition Switch”, in the section
“Instruments and Controls”.