Case 845B VHP - Page 20

CHAPTER 2 – SAFETY / DECALS / HAND SIGNALS
2-4
Start Up
Do not start or operate an unsafe machine. Before •
working the machine, be sure that any unsafe condi-
tion has been satisfactorily remedied.
Check brakes and steering and attachment controls •
before moving. Advise the proper maintenance autho-
rity of any malfunction part or system.
Before starting machine, check, adjust and lock the •
operator’s seat for maximum comfort and control of
the machine.
Be sure all people in the area are clear of the unit •
before releasing the parking brake or moving the ma-
chine or its attachments. Walk completely around ma-
chine before mounting. Sound horn.
Obey agman, safety signals and signs. •
Due to the presence of ammable uid, never check or •
ll fuel tanks, storage batteries, or use starter uid near
lighted smoking materials or open ame or sparks.
Operating
Do not run the engine of this machine in closed area •
without proper ventilation to remove deadly exhaust
gases.
Do not use machine to carry loose objects by means •
other than attachments designed for such objects.
Do not carry riders unless the machine is equipped for •
carrying people to reduce personal exposure to being
thrown off.
Observe and know the mechanics of alternate exit •
routes.
Do not attempt to climb on or off machine while it is •
in motion.
When operating always look at the direction of the •
movement of the machine. Be sure exposed person-
nel in the area of operation are clear of the unit before
moving the machine or its attachments, mainly chil-
dren. If someone arrives in operation area, stop the
machine immediately.
Maintain a safe distance from other machines. Provi- •
de sufcient clearance for ground and visibility con-
ditions.
Shut Down
Never leave the machine unattended with the engi- •
ne running. Always before leaving the operator’s seat
and after making certain all people are clear of the
machine, slowly lower attachments or tools at to the
ground in a positive ground support position. Move
any multipurpose tool or attachment to positive closed
position. Return the controls to hold. Place transmis-
sion control in neutral and move engine controls to off
position. Engage all control locks, set parking brake,
and open and lock the master (key) switch.
Park in a nonoperating and non-trafc area or as ins- •
tructed.
Park on rm level ground if possible. Where not pos- •
sible, position machine at a right angle to the slope,
making sure there is no danger of uncontrolled sliding
movement. Set the parking brake. If parking in trafc
lanes cannot be avoided, provide appropriate ags,
barriers, ares and warning signals in the trafc lane
for approaching trafc.
Never lower attachments or tools from any position •
other than seated in operator’s seat.