CHAPTER 4 – OPERATING INSTRUCTIONS
4-3
FIRST SERVICE INTERVALS
The following items are to be done during the Run-In Period and are in addition to the items in the Lubrications / Main-
tenance Charts in this manual.
AFTER FIRST 100 HOURS OF OPERATION
Change the transmission oil and lter when the transmission is new or repaired
(only models 845B / 865B / 885B with ZF transmission) .......................................... See “Transmission” in this manual
Check all hose clamps, tighten as required.
SEAT BELT
Always securely fasten your seat belt before operating the machine. From time to time, carefully inspect the seat belts
for worn areas and replace belts when needed.
WARNING: Securely fasten your seat belt. Your machine is equipped with a ROPS cab or canopy for your
protection. The seat belt can help insure your safety if it is used correctly and maintained. Never wear a seat
belt loosely or with slack in the belt system. Never wear the seat belt in a twisted condition.
DIFFERENTIAL LOCK
(Optional for 845B models and standard for 865B and 885B models)
The differential block must be used only for 1st and 2nd gears (ZP and FUNK transmissions) straight, in operations
requiring higher traction (level curves, very hard soil, or when there is a need for moving large amounts of material).
NOTE: For maneuvers in trafc, in urban ways or roads, in performing curves or at higher gears (3rd gear and above),
NEVER use the differential lock, since it could cause damages to the rear shaft and also excessive wear of rear tires.
To Next Page
Loading...
