106
Using BEST SHOT
4. Press [SET].
• Time Lapse settings are shown at the bottom of
the screen.
5. Press the shutter button to start recording.
• Shooting is repeated at the interval specified in
step 3.
• Recording stops when the recording time
specified in step 3 elapses or when the shutter
button is pressed again.
• Remaining recording time is not displayed
when the “ Total Time” setting is “Off”.
• During Time Lapse recording, the monitor screen will turn off in accordance with
the “Sleep” setting (page 197). Change the “Sleep” setting to “Off” if you want the
monitor screen to stay on. Note, however, that this setting will use up battery power
more quickly.
• If sleep is enabled (page 197), the monitor screen will turn off after the preset sleep
period if no camera operation is performed, but the time lapse recording operation
will continue. The camera’s back lamp will flash at this time. Performing any
operation while the monitor screen is blank will turn it back on. However, the
following operations will not turn the monitor screen back on.
– Pressing [ON/OFF] (Power)
– Pressing the shutter button all the way
– Rotating the mode dial
• The Auto Power Off is disabled while time lapse recording is in progress (page
197).
• The following functions cannot be used with this function.
Single SR Zoom, Anti-shake Functions, Lighting, Continuous AF, Triple Self-timer,
Motion Shutter, Face Detection, Metering, ISO, ISO High Limit, Make-up
• The frame rate of playback of movies shot with this function is 20 fps. Movie quality
is always FHD.
• Note that audio is not recorded when recording with this function.
• The camera can be configured to play only Time Lapse movies during a slideshow
(page 144).
• You cannot shoot a snapshot by pressing the shutter button while time lapse
recording is in progress (Snapshot In Movie).
Remaining recording time
Recording time
To Next Page
Loading...
Need help?
General
