156
PLAYBACK
IMPORTANT!
• All icons and indicators that appear on the monitor
screen also appear on the TV screen.
• Note that the audio output is monaural.
• The camera’s monitor screen will go blank during
video output.
• Pressing the USB cradle’s [PHOTO] button will
activate the Photo Stand feature (page 149) and
display images on the TV screen.
• Depending on the size of the TV screen, recorded
images may not fill the entire screen.
• For video output, the audio volume level is initially
set to maximum. Perform volume level adjustment
using TV controls.
• After using an optionally available AV cable (EMC-
2A) to connect the camera’s USB cradle connector
directly to the AUDIO IN terminal of a TV, you can
view recorded images on the TV and even use the
TV screen to compose images before recording
them.
Selecting the Video Output System
You can select either NTSC or PAL for the video output
system to match the system of the TV you are using.
1.
In a REC mode or the PLAY mode, press
[MENU].
2.
Select the “Set Up” tab, select “Video Out”,
and then press [왘].
3.
Use [왖] and [왔] to select the setting you
want, and then press [SET].
If you are using a TV designed
for use in this area:
U.S., Japan, and other areas
that use the NTSC system
Europe and other areas that
use the PAL system
Select this setting:
NTSC
PAL
B
To Next Page
Loading...
Need help?
General
