OTHER SETTINGS
175
Select this setting:
Power On
Power On/Off
Disable
To configure this operation:
Power turns on when [
] (REC) or
[
] (PLAY) is pressed (but does not
turn off)
Power turns on or off when [
]
(REC) or [ ] (PLAY) is pressed
Power does not turn on or off when
[
] (REC) or [ ] (PLAY) is
pressed
IMPORTANT!
• When “Power On/Off” is selected, pressing [ ]
(REC) in a REC mode or [ ] (PLAY) in the PLAY
mode turns off the camera.
• Pressing [ ] (REC) in the PLAY mode switches to
the currently selected recording mode, and pressing
[ ] (PLAY) in a REC mode switches to the PLAY
mode.
NOTE
• The initial default setting is “Power On”.
Formatting Built-in Memory
Formatting built-in memory deletes any data stored in it.
IMPORTANT!
• Note that data deleted by a format operation cannot
be recovered. Check to make sure you do not need
any of the data in memory before you format it.
• Formatting built-in memory deletes the following.
— Protected images
— FAVORITE folder images
— BEST SHOT mode user setups
— MOVIE BEST SHOT mode user setups
— Startup screen image
1.
Check to make sure there is no memory card
loaded in the camera.
• If there is a memory card loaded in the camera,
remove it (page 179).
2.
Press [MENU].
3.
Select the “Set Up” tab, select “Format”, and
then press [왘].
To Next Page
Loading...
Need help?
General
