Check Point QUANTUM MAESTRO - Page 120

Connecting Cables to MHO-170
Quantum Maestro Getting Started Guide|120
Item Description
15 A Security Appliance that is assigned to the Security Group 1 (17).
16 A Security Appliance that is assigned to the Security Group 1 (17).
17 All Security Appliances assigned to the Security Group 1.
Table: Explanations (continued)
Notes:
n
Port 32 (colored purple) is the dedicated synchronization port to connect two MHO-170 for
redundancy on the same site.
n
It is possible to configure some of the Uplink ports as additional Downlink ports.
See the Maestro Administration Guide for your version > Chapter Configuration Procedure >
Section Configuring Security Groups > Section Configuring Security Groups in Gaia Clish > Section
Configuring the Port Settings .
n
The Quantum Maestro Orchestrators create Link Aggregation for the applicable Downlink ports
automatically.
n
See these sections:
l
"Connecting cables between each Quantum Maestro Orchestrator and ports on the Dual Port
Card on each Security Appliance" on page92
l
"Connecting cables between each Quantum Maestro Orchestrator and 1 out of 4 ports on the
Quad Port Card on each Security Appliance" on page92