Check Point QUANTUM MAESTRO - Page 24

Hardware Components
Quantum Maestro Getting Started Guide|24
Item Description
7
RJ45 port with the label . See "MGMT Ports" on page45 .
To this port you connect a client, from which you configure the Gaia Operating System on the
Quantum Maestro Orchestrator (in Gaia Portal, or Gaia Clish).
8 RJ45 port with the label . See "Console Port" on page48 .
To this port you connect a client, from which you configure the Gaia Operating System on the
Quantum Maestro Orchestrator (in Gaia Clish).
9 Synchronization port 32 (colored purple).
You connect a DAC cable between ports 32 on two Quantum Maestro Orchestrators MHO-175
for redundancy on the same site.
10 Button to select indication states for the splitting control LEDs. See "MHO-175 Splitting
Options" on page83 .
11 Splitting control LEDs that show the indication state for Port LEDs:
n
State of which port to show (without a split cable).
n
State of which split port to show (in 1-to-2 split, or 1-to-4 split).
See "MHO-175 Splitting Options" on page83 .
12 Port LEDs that show the status of all ports (including the split ports).
13 Need to add such callout
Reset button with the label RST. See "Reset Button" on page49 .
Notes:
n
It is possible to connect DAC or Fiber cable (with transceivers) to each port (from
1 to 32).
n
It is possible to connect Breakout cables to each port. See "MHO-175 Splitting
Options" on page83 .