Check Point QUANTUM MAESTRO - Page 96

Connecting Two Quantum Maestro Orchestrators for Redundancy
Quantum Maestro Getting Started Guide|96
Step Device Instructions
5 On the first
Quantum
Maestro
Orchestrator
(15)
With cable (9), connect the Management Server to the Management port
(in our example, Port 1).
In our example, we used a Breakout cable because we have two Security
Groups.
For more information that applies to MHO-175, see:
n
"Connecting to the Management Port with DAC or Fiber Cables" on
page98
n
"Connecting to the Management Port with Breakout Cables" on
page100
For more information that applies to MHO-170, see:
n
"Connecting to the Management Ports with DAC or Fiber Cables"
on page109
n
"Connecting to the Management Ports with Breakout Cables" on
page111
For more information that applies to MHO-140, see:
n
"Connecting to the Management Ports with DAC or Fiber Cables"
on page121
Table: Workflow (continued)