NOTE: Right side shown, left side similar.
1 - Rear Rail Lower Closeout Cut Line
2 - Rear Rail Lower Closeout (590 MPa)
CAUTION: To prevent damage to the Inner Reinforcement , extreme care must be taken while cutting the
rail.
NOTE: It will be necessary to order the complete rear rail and create the sectioning portions at the same
cut lines.
The rear rail lower closeout (2) sectioning cut line (1) is located at the forward edge of the square Principle Location
Point (PLP).
Rear Rail Lower Closeout
31 - 50 31 - Collision Information RU
To Next Page
