Cimbali M26 - Page 72

1 32
4 5
A
1 42
5 7
3
6
English
26 EN
FILTER-HOLDERS - 7KLVRSHUDWLRQPXVWEHPDGHRQDOOWKH¿OWHUKROGHUVDWWKHHQGRIHDFKZRUNLQJGD\
5HPRYHWKH¿OWHUVIURPWKH¿OWHUKROGHUV
6RDNWKH¿OWHUVDQGWKH¿OWHU
holders in this solution for
about 15 minutes.
NOTE! Only immerse the
metal parts.
3ODFHWKH¿OWHUVEDFNLQWKH¿OWHUKROGHUPDNLQJVXUHWKDW
the anchoring spring (ARIWKH¿OWHULVLQLWVVORW
Remove the filter holder
IURPWKHFRႇHHJURXS
Using a brush, clean the
cover gasket.
$WWDFKWKH¿OWHUKROGHUWRWKH
dispenser unit.
5HPRYHWKH¿OWHUKROGHU3UHVVWKH67$576723EXWWRQ
and execute the rinse cycle with water for about 30”.
Pour in a packet or dosing
cupful of detergent powder.
Press the START/STOP
button and press it again
after 10 seconds. Repeat
this step 10 times.
Do not remove the
¿OWHU KROGHU GXULQJ
FRႇHHGLVSHQVLQJ
Insert the rubber disk into
WKH¿OWHUKROGHUZLWKLWV¿OWHU
Groups of C version
Pour one litre of hot water
(50÷80°C) and 10 g of
detergent powder, equal to
two teaspoCons, in a suitable
container that is neither
aluminium nor iron.
Remove any residue with a non-abrasive sponge and rinse
well with running cold water.
Operation to be carried out on all groups at the end of each working day.
02_M26_UNICO_EU_2314.indd 26
02_M26_UNICO_EU_2314.indd 26
07/04/2023 12:05:34
07/04/2023 12:05:34