97
Update
Chapter 3
Setting up a WPAN Connection
6. Wait for a few seconds for the Wizard to search available devices nearby.
The scanner will appear with its “serial number” as the device name. You may double-check the
“Serial Number” label on the scanner to ensure connecting with the correct scanner. Select the
target scanner. If the target scanner does not appear on the list, click [Search Again] to refresh
the list. The scanner might enter Suspend Mode now, and you can press the trigger to have it
active again (=discoverable). It will then stay active for a specified period of time (2 minutes by
default) and wait for PC to establish a connection.
7. Click [Next].
To Next Page
Loading...
Need help?
General
