41
Update
Chapter 1
Understanding the Barcode Scanner
1.11 AUTO-SENSE MODE (1560 ONLY)
This mode is only available when you want to seat the scanner in the Auto-Sense stand.
When you enable this mode, it will force the scanner to apply Laser mode as the scan
mode. However, it works differently from the original Laser mode. Now the scanner will
be scanning as long as it is seated in the Auto-Sense stand, as shown below. Whenever a
barcode is brought within range, the scanner will be able to decode it.
Note: To stop this mode, you may remove the scanner from the stand or have the
scanner read the “Disable (Auto-Sense)” label below. It will return to Laser mode.
If Laser mode is not desired, proceed to select a scan mode best suits your
application.
Note: For Auto-Sense mode to work, you must connect both the power supply cord and
the interface cable to the Auto-Sense stand. USB power is insufficient.
*Disable
Enable
To Next Page
Loading...
Need help?
General
