21
Update
Chapter 1
Understanding the Barcode Scanner
1) Read the label above to specify the time interval before the scanner automatically
turns off.
2) Read the “
Decimal Value” label on page 205. For example, read “1” and “5” for the
scanner to automatically turn off after being idle for 15 minutes.
3) Read the “Validate” label on the same page to complete this setting.
Note: Auto Power Off will not take effect when one of the following conditions is met:
(1) the scanner is in the configuration mode, or
(2) 1560 is in Auto-Sense mode and seated in the 3656 stand.
1) Read the label above to specify the time interval before the scanner automatically
turns off.
2) Read the “
Decimal Value” label on page 205. For example, read “1” and “5” for the
scanner to automatically turn off after being idle for 15 minutes.
3) Read the “Validate” label on the same page to complete this setting.
Note: Power-Saving will not take effect when one of the following conditions is met:
(1) the scanner has already established a BT HID/SPP connection,
(2) the scanner is in the configuration mode,
(3) the scan mode is set to Test, Continuous or Alternate Mode,
(4) 1560 is in Auto-Sense mode and seated in the 3656 stand, or
(5) the setting value of Power-Saving is greater than that of Auto Power Off.
uto Off after 0~254 minutes (*10)
ower-Saving after 0~254 minutes (*
To Next Page
Loading...
Need help?
General
