Circutor DHC-96 Aac - Page 16

On the rEAd screen, press the , key to access the conguration menu in the display
mode, i.e., the conguration parameters cannot be modied.
On the rEAd screen, press the or keys to access the conguration menu in the
programming mode, i.e., the conguration parameters can be modied.
rEAd
ProG
CodE
0000
inPt
Figure 8: Access the conguration menu in the programming mode.
Before accessing the conguration menu, it is necessary to enter the access password.
CodE
0000
Figure 9: Access password�
Use the , key to modify the value of the ashing digit
When the desired value is shown on the screen, press the key to skip the digit.
Default password: 0001
Note : The password can be modied, see “5.6.1.- PASSWORD OF ACCESS”�
To validate the data, press the key.
If the password entered is incorrect, the Errmessage will appear for a few seconds and the
device will return to the password conguration screen, Figure 9.
16
DHC-96 Aac
Instruction Manual