Cirrus DESIGN SR20 - Page 119

Cirrus Design Section 4
SR20 Normal Procedures
P/N 11934-004 4-11
6. Power Lever ........................................................FULL FORWARD
7. Fuel Pump ....................................................PRIME, then BOOST
• Note •
On first start of the day, especially under cool ambient
conditions, holding Fuel Pump switch to PRIME for 2 seconds
will improve starting.
8. Propeller Area..................................................................... CLEAR
9. Power Lever ...........................................................OPEN ¼ INCH
10. Ignition Switch....................... START (Release after engine starts)
• Caution •
Limit cranking to intervals of 20 seconds with a 20 second
cooling period between cranks. This will improve battery and
contactor life.
11. Power Lever ..............................RETARD (to maintain 1000 RPM)
12. Oil Pressure ....................................................................... CHECK
13. Alt Master Switches ...................................................................ON
14. Avionics Power Switch ...............................................................ON
15. Engine Parameters ........................................................ MONITOR
16. External Power (If applicable) ................................. DISCONNECT
17. Amp Meter/Indication......................................................... CHECK
Original Issue