7-14 P/N 11934-004
Section 7 Cirrus Design
Airplane and Systems Description SR20
Instrument Panel
The instrument panel is of all metal construction and is installed in
sections so equipment can be easily removed for maintenance. The
surrounding glareshield is made of composite material and projects
over the instrument panel to reduce reflections on the windshield from
lighted equipment and to shield the panel equipment from glare.
Pilot Panel Arrangement
Two color landscape-oriented electronic flight displays are installed to
the instrument panel; the Primary Flight Display (PFD) and the
Multifunction Display (MFD). The PFD, installed directly in front of the
pilot, is a intended to be the primary display of flight parameter
information (attitude, airspeed, heading, and altitude). The MFD,
installed to the right of the PFD, provides supplemental situational and
navigation information to the pilot. The ignition switch is located on the
left side of the instrument panel. The cabin environmental control
switches are located on the right side of the instrument panel.
Instrument panel air vents are located on the outboard sections of the
panel.
Center Console Arrangement
A center console contains the Flight Management System Keyboard,
autopilot and audio controls, flap system control and indication, fuel
system indicator and controls, and the power and mixture levers.
System circuit breakers, the alternate static source valve, alternate
induction air control, and the ELT panel switch are located on the left
side of the console. A friction knob for adjusting throttle and mixture
control feel and position stability is located on the right side of the
console. The accessory outlet, map compartment, audio jacks, hour
meters, and emergency egress hammer are installed inside the
console armrest.
Bolster Panel Arrangement
A switch panel located in the “dash board” bolster below the
instrument panel contains the master, avionics power, Pitot heat, and
exterior and interior lighting switches and controls. The standby
airspeed, attitude, and altimeter instruments are located below bolster
switch panel.
Original Issue