2-6 P/N 11934-004
Section 2 Cirrus Design
Limitations SR20
Powerplant Limitations
Engine
Teledyne Continental............................................................IO-360-ES
Power Rating ........................................................ 200 hp @ 2700 rpm
Maximum RPM.......................................................................2700 rpm
Oil Temperature.......................................... 240° F (115° C) maximum
Oil Pressure:
Minimum................................................................................ 10 psi
Maximum............................................................................. 100 psi
Approved Oils:
Engine Break-In: For first 25 hours of operation or until oil
consumption stabilizes use straight mineral oil conforming to MIL-
L-6082. If engine oil must be added to the factory installed oil, add
only MIL-L-6082 straight mineral oil.
After Engine Break-In: Use only oils conforming to Teledyne
Continental Specification MHS-24 (Ashless Dispersant Lubrication
Oil) or MHS-25 (Synthetic Lubrication Oil). Refer to Section 8 - Oil
Servicing. Oil viscosity range as follows:
All Temperatures ..............................................15W-50 or 20W-50
Above 40 ° F (4° C)............................................ SAE 50 or 20W50
Below 40 ° F (4° C) ............... SAE 30, 10W-30, 15W50, or 20W50
Fuel Grade ................Aviation Grade 100 LL (Blue) or 100 (green)
• Note •
Refer to Fuel Limits in this section for operational limitations
regarding fuel and fuel storage.
Revision 1
To Next Page
Loading...
