Cirrus DESIGN SR20 - Engine Failures; Engine Failure on Takeoff (Low Altitude); Original Issue

Cirrus Design Section 3
SR20 Emergency Procedures
P/N 11934-004 3-7
Engine Failures
Engine Failure On Takeoff (Low Altitude)
If the engine fails immediately after becoming airborne, abort on the
runway if possible. If altitude precludes a runway stop but is not
sufficient to restart the engine, lower the nose to maintain airspeed
and establish a glide attitude. In most cases, the landing should be
made straight ahead, turning only to avoid obstructions. After
establishing a glide for landing, perform as many of the checklist items
as time permits.
• WARNING •
If a turn back to the runway is elected, be very careful not to
stall the airplane.
1.
Best Glide or Landing Speed (as appropriate) ........... ESTABLISH
2. Mixture..............................................................................CUTOFF
3. Fuel Selector............................................................................OFF
4. Ignition Switch..........................................................................OFF
5. Flaps...................................................................... AS REQUIRED
If time permits:
6. Power Lever ............................................................................ IDLE
7. Fuel Pump ...............................................................................OFF
8. Bat-Alt Master Switches...........................................................OFF
9. Seat Belts ..................................................... ENSURE SECURED
Original Issue