Cirrus DESIGN SR20 - Wing Fire in Flight; Engine Fire During Start; Original Issue

3-12 P/N 11934-004
Section 3 Cirrus Design
Emergency Procedures SR20
Wing Fire In Flight
1. Pitot Heat Switch......................................................................OFF
2. Navigation Light Switch............................................................OFF
3. Landing Light ...........................................................................OFF
4. Strobe Light Switch..................................................................OFF
5. If possible, side slip to keep flames away from fuel tank and cabin.
• Note •
Putting the airplane into a dive may blow out the fire. Do not
exceed V
NE
during the dive.
6.
Land as soon as possible.
Engine Fire During Start
A fire during engine start may be caused by fuel igniting in the fuel
induction system. If this occurs, attempt to draw the fire back into the
engine by continuing to crank the engine.
1.
Mixture ............................................................................. CUTOFF
2. Fuel Pump................................................................................OFF
3. Fuel Selector............................................................................OFF
4. Power Lever ..................................................................FORWARD
5. Starter ................................................................................ CRANK
6. If flames persist, perform Emergency Engine Shutdown on
Ground and Emergency Ground Egress checklists.
Original Issue