CISA eSIGNO - Wave Mode Lock Maintenance

ESIGNO_SYSTEM_USER_MANUAL_101.DOCX 69/71
M
MM
MAINTENANCE
AINTENANCEAINTENANCE
AINTENANCE
(
((
(6
66
6)
))
)
S
SS
SERVICE
ERVICE ERVICE
ERVICE O
OO
OPERATIONS
PERATIONSPERATIONS
PERATIONS
W
WW
W
AVE
AVE AVE
AVE
M
MM
M
ODE
ODE ODE
ODE
L
LL
L
OCK
OCKOCK
OCK
B
BB
B ATTERY
ATTERY ATTERY
ATTERY S
SS
S TATUS
TATUSTATUS
TATUS
The battery status control can be done using any valid staff card; there are 2 different warning levels:
• low battery status: the LED signal gives 3 red + green blinks before lock opening;
• end battery status: the LED signal gives 12 red + green blinks before lock opening.
These warnings are also recorded into lock history as separate events with respect to the openings.
Steps to change batteries:
Steps to change batteries:Steps to change batteries:
Steps to change batteries:
With the proper tool, it is possible to remove the batteries holder cover as shown in figure below. 3
alkaline AA LR6 type batteries are needed.
E
EE
E MERGENCY
MERGENCY MERGENCY
MERGENCY M
MM
M ECHANICAL
ECHANICAL ECHANICAL
ECHANICAL C
CC
C YLINDER
YLINDERYLINDER
YLINDER
The electronic locks always have an emergency mechanical cylinder with variable key bitting.
The cylinder works with 3 different keys (number from 1 to 3):
• key number 1 must be used first;
• in case of key number 1 has been lost or has not been considered secure, key number 2 can be
used. In this case the use of the key number 1 is blocked;
• in the same way, using key number 3, key number 2 will be disabled.
Independently from the key you are using, follow this procedure:
• insert the mechanical key and turn 360° in the clockwise direction;
• rotate the knob (external handle).