EasyManuals Logo

Cisco 2800 Series User Manual

Cisco 2800 Series
266 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
7
Overview
OL-6154-01
Performing Initial Configuration
Initial Configuration Using the Command-Line Interface
This section describes briefly how to display a command-line interface (CLI) prompt for configuration
using the CLI.
You can use the CLI if the following messages appear at the end of the startup sequence:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
If these messages do not appear, SDM and a default configuration file were installed on the router at the
factory. To use SDM to configure the router, see the
“Initial Configuration Using the Cisco Router and
Security Device Manager” section on page 3.
Note
Be sure to save your configuration changes occasionally so that they are not lost during resets, power
cycles, or power outages. Use the copy
running-config startup-config command at the privileged
EXEC mode prompt (Router#) to save the configuration to NVRAM.
Step 1
To proceed with manual configuration using the CLI, enter no when the power-up messages end:
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2
Press Return to terminate autoinstall and continue with manual configuration:
Would you like to terminate autoinstall? [yes] Return
Several messages appear, ending with a line similar to the following:
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled <date> <time> by <person>
Step 3
Press Return to display the Router> prompt:
...
flashfs[4]: Initialization complete.
Router>
Step 4
Enter privileged EXEC mode:
Router> enable
Router#
Step 5
Verify the initial configuration. See the “Verifying the Initial Configuration” section on page 8 for
verification procedures.
For more information on using the CLI for router configuration, see the Basic Software Configuration
Using the Cisco IOS Command-Line Interface section, available at this URL:
http://www.cisco.com/en/US/docs/routers/access/1800/1841/software/configuration/guide/b_cli.html

Table of Contents

Other manuals for Cisco 2800 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 2800 Series and is the answer not in the manual?

Cisco 2800 Series Specifications

General IconGeneral
Power SupplyInternal power supply
Product TypeRouter
Form FactorRack-mountable
Connectivity TechnologyWired
Power DeviceInternal power supply
Operating SystemCisco IOS
Integrated ServicesSecurity, voice
WAN InterfacesT1/E1, Serial
LAN InterfacesFast Ethernet, Gigabit Ethernet
Expansion Slots4
Data Link ProtocolEthernet, Fast Ethernet, Gigabit Ethernet
Network/Transport ProtocolIP, TCP
Remote Management ProtocolSNMP, Telnet
FeaturesVPN support, Quality of Service (QoS), VLAN support
Voltage RequiredAC 100-240 V
Security FeaturesFirewall, VPN, Access Control Lists (ACLs)

Related product manuals