Cisco 2800 Series - Branch 1 Router Configuration (Cisco 2801 Router)

Hoot and Holler over V3PN Configuration Example
Configure
9
OL-6573-01
! SPECIFY TRAFFIC TO BE ENCRYPTED (HERE IT'S ALL GRE TRAFFIC)
!
ip access-list extended IPSEC_ACL_1
permit gre host 10.32.152.26 host 10.32.150.46
ip access-list extended IPSEC_ACL_2
permit gre host 10.32.152.26 host 10.32.153.34
!
!
control-plane
!
!CONFIGURE THE VOICE PORT AND LINK IT TO DIAL-PEER 100. THIS CONNECTION IS PERMANENT. THE
VOICE-CLASS WAS DEFINED EARLIER IN THE CONFIGURATION, AND ESTABLISHES AN 'ALWAYS ON'
CONNECTION
!
voice-port 0/1/0
voice-class permanent 1
timeouts call-disconnect 3
connection trunk 100
!
voice-port 0/1/1
!
!
!
!THIS DIAL-PEER CONNECTS THE VOICE PORT TO MULTICAST GROUP 239.168.1.100. g711 CODEC (64k)
IS USED, AND VAD IS ENABLED
!
dial-peer voice 100 voip
destination-pattern 100
session protocol multicast
session target ipv4:239.168.1.100:19890
codec g711ulaw
vad aggressive
!
!
!
line con 0
stopbits 1
line aux 0
stopbits 1
line vty 0 4
login authentication USERLIST
!
end
!
Branch 1 Router Configuration (Cisco 2801 Router)
Branch-1# show running-config
Building configuration...
Current configuration : 6300 bytes
!
! Last configuration change at 03:11:55 UTC Sat Apr 17 2004
! NVRAM config last updated at 02:03:50 UTC Sat Apr 17 2004
!
version 12.3
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
!