Cisco 2800 Series - Page 148

Hoot and Holler over V3PN Configuration Example
Configure
8
OL-6573-01
ip address 10.32.152.26 255.255.255.252
ip ospf network point-to-point
no atm ilmi-keepalive
crypto map INT_CM
pvc 10/100
protocol ip 10.32.152.25 broadcast
vbr-rt 100000 100000
service-policy output LLQ
!
! PLACE ALL SWITCHPORT INTERFACES INTO VLAN 10
!
interface FastEthernet4/0
switchport access vlan 10
no ip address
!
interface FastEthernet4/1
switchport access vlan 10
no ip address
!
! ... REDUNDANT FAST ETHERNET CONFIGURATION OMITTED.
!
interface FastEthernet4/15
switchport access vlan 10
no ip address
!
interface GigabitEthernet4/0
no ip address
shutdown
!
interface Vlan1
no ip address
!
! INTERFACE FOR CONNECTING INTERNAL HOSTS.
!
interface Vlan10
description === Private interface ===
ip address 192.168.1.1 255.255.255.0
ip pim sparse-dense-mode
!
! ENABLE ROUTING FOR ALL RELEVANT NETWORKS (INTERNAL USER SUBNET, LOOPBACK FOR RP AND VIF
FOR VOICE)
!
router ospf 1
log-adjacency-changes
network 192.168.1.0 0.0.0.255 area 0
network 192.168.4.1 0.0.0.0 area 0
network 192.168.6.0 0.0.0.255 area 0
!
! DEFINE STATIC ROUTES SO THAT THE REMOTE NETWORKS STAY IN THE ROUTING TABLE, EVEN IF
CONNECTION IS LOST
! THIS PREVENTS ROUTING TABLE FLAPS
!
ip classless
ip route 0.0.0.0 0.0.0.0 10.32.152.25
ip route 192.168.2.0 255.255.255.0 Null0 249
ip route 192.168.3.0 255.255.255.0 Null0 249
!
ip http server
no ip http secure-server
!
! CONFIGURE AUTOMATIC DISCOVERY OF GROUP-TO-RENDEZVOUS POINT (AUTO-RP)
!
ip pim send-rp-announce Loopback100 scope 5
ip pim send-rp-discovery Loopback100 scope 5