Hoot and Holler over V3PN Configuration Example
Verify
17
OL-6573-01
dial-peer voice 100 voip
destination-pattern 100
session protocol multicast
session target ipv4:239.168.1.100:19890
codec g711ulaw
vad aggressive
!
!
!
line con 0
exec-timeout 0 0
line aux 0
line vty 0 4
password 7 0002000E0D4B
login authentication USERLIST
!
!
end
Verify
This section provides information you can use to confirm your configuration is working properly. The
verification process includes two parts:
•
Verify Headquarters Connectivity, page 17
•
Verify Remote Location Connectivity, page 27
Verify Headquarters Connectivity
This section provides instructions for verifying that your configuration works properly.
Certain show commands are supported by the Output Interpreter Tool (registered customers only),
which allows you to view an analysis of show command output.
In summary:
•
show crypto isakmp sa—Shows whether the remote routers have successfully connected.
•
show crypto ipsec sa—Shows information about each IPSec SA.
•
show ip ospf neighbor—Shows whether the router has Open Shortest Path First (OSPF) neighbors.
•
show ip route—Shows whether the remote networks and multicast subnets are accessible (assess
routing table).
•
show ip pim neighbor—After a routing table is verified, shows whether a valid Protocol
Independent Multicast (PIM) neighbor exists.
•
show ip pim rp map—Shows whether the rendezvous point (RP) (in this instance, the router) is
being correctly learned.
•
show ip mroute active—Shows whether any active multicast streams exist (in this case, voice
streams).
•
show voice trunk-conditioning supervisory—Shows whether the voice port connection is up.
•
show voip rtp connections—Presents sources and destination of a RTP voice stream.
To Next Page
Loading...
Need help?
General
