Cisco 2800 Series User Manual

11
Basic Software Configuration Using the Setup Command Facility
OL-5992-01
Examples of Using the Setup Command Facility to Configure Interface Parameters
Do you want to map the remote machine’s smds address to IP address? [yes]:
IP address for the remote interface: 192.0.0.2
Do you want to map the remote machine’s smds address to IPX address? [yes]:
IPX address for the remote interface: 40.1234.5678
Asynchronous/Synchronous Serial Interface—Asynchronous Configuration
The following is a sample configuration for asynchronous configuration for an
asynchronous/synchronous serial interface:
Do you want to configure Serial1/1 interface? [yes]:
Enter mode (async/sync) [sync]: async
Configure IP on this interface? [yes]:
Configure IP unnumbered on this interface? [no]:
IP address for this interface: 192.0.0.0
Subnet mask for this interface [255.0.0.0]:
Class A network is 2.0.0.0, 0 subnet bits; mask is /8
Configure LAT on this interface? [no]:
Configure AppleTalk on this interface? [no]:
Configure DECnet on this interface? [no]:
Configure CLNS on this interface? [no]:
Configure IPX on this interface? [no]: yes
IPX network number [8]:
Configure Vines on this interface? [no]:
Configure XNS on this interface? [no]:
Configure Apollo on this interface? [no]:
Asynchronous/Synchronous Serial Interface—Synchronous Configuration
The following is a sample configuration for synchronous configuration for an
asynchronous/synchronous serial interface:
Do you want to configure Serial1/0 interface? [yes]:
Enter mode (async/sync) [sync]:
Some supported encapsulations are
ppp/hdlc/frame-relay/lapb/x25/atm-dxi/smds
Choose encapsulation type [hdlc]:
Note The following sections describe the prompts for each encapsulation type. For PPP and High-Level Data
Link Control (HDLC) encapsulation, no further configuration is needed.
No serial cable seen.
Choose mode from (dce/dte) [dte]:
If no cable is plugged in to your router, you must indicate whether the interface is to be used as DTE or
DCE. If a cable is present, the setup command facility determines the DTE/DCE status. If the serial cable
is DCE, you see the following prompt:
Configure IP on this interface? [no]: yes
Configure IP unnumbered on this interface? [no]:
IP address for this interface: 192.0.0.0
Subnet mask for this interface [255.0.0.0]:
Class A network is 2.0.0.0, 0 subnet bits; mask is /8
Configure LAT on this interface? [no]:

Cisco 2800 Series Specifications

General

Power Supply	Internal power supply
Product Type	Router
Form Factor	Rack-mountable
Connectivity Technology	Wired
Power Device	Internal power supply
Operating System	Cisco IOS
Integrated Services	Security, voice
WAN Interfaces	T1/E1, Serial
LAN Interfaces	Fast Ethernet, Gigabit Ethernet
Expansion Slots	4
Data Link Protocol	Ethernet, Fast Ethernet, Gigabit Ethernet
Network/Transport Protocol	IP, TCP
Remote Management Protocol	SNMP, Telnet
Features	VPN support, Quality of Service (QoS), VLAN support
Voltage Required	AC 100-240 V
Security Features	Firewall, VPN, Access Control Lists (ACLs)