10
Basic Software Configuration Using the Setup Command Facility
OL-5992-01
Examples of Using the Setup Command Facility to Configure Interface Parameters
Class A network is 2.0.0.0, 8 subnet bits; mask is /8
If Internetwork Packet Exchange (IPX) is configured on the router, the setup command facility prompts
you for the IPX map:
Do you want to map a remote machine's IPX address to dlci? [yes]:
IPX address for the remote interface: 40.0060.34c6.90ed
Link Access Procedure, Balanced Encapsulation
The following is a sample of configuration for Link Access Procedure, Balanced (LAPB) encapsulation,
selecting either DCE or DTE mode, with DTE as the default:
lapb circuit can be either in dce/dte mode.
Choose either from (dce/dte) [dte]:
X.25 Encapsulation
The following is an example of X.25 encapsulation:
x25 circuit can be either in dce/dte mode.
Choose from either dce/dte [dte]:
Enter local x25 address: 1234
We will need to map the remote x.25 station’s x25 address
to the remote station’s IP/IPX address
Enter remote x25 address: 4321
Do you want to map the remote machine’s x25 address to IP address? [yes]:
IP address for the remote interface: 192.0.0.2
Do you want to map the remote machine’s x25 address to IPX address? [yes]:
IPX address for the remote interface: 40.1234.5678
Enter lowest 2-way channel [1]:
Enter highest 2-way channel [64]:
Enter frame window (K) [7]:
Enter Packet window (W) [2]:
Enter Packet size (must be powers of 2) [128]:
ATM Data Exchange Interface Encapsulation
The following is an example of asynchronous transfer mode data exchange interface (ATM-DXI)
encapsulation:
Enter VPI number [1]:
Enter VCI number [1]:
Do you want to map the remote machine’s IP address to vpi and vci? [yes]:
IP address for the remote interface: 192.0.0.2
Do you want to map the remote machine’s IPX address to vpi and vci? [yes]:
IPX address for the remote interface: 40.1234.5678
Switched Multimegabit Data Service Encapsulation
The following is a sample configuration for switched multimegabit data service (SMDS) encapsulation:
Enter smds address for the local interface: c141.5556.1415
We will need to map the remote smds station’s address
to the remote station’s IP/IPX address
Enter smds address for the remote interface: c141.5556.1414
To Next Page
Loading...
Need help?
General
