Cisco 2800 Series - Page 147

Hoot and Holler over V3PN Configuration Example
Configure
7
OL-6573-01
! CREATE TUNNELS TO THE SPOKE ROUTERS. THE MTU IS LOWERED TO ALLOW THE GRE AND IP-SEC
HEADER
! PIM SD IS ENABLED SO AS TO ALLOW MULTICAST, AND THE TUNNEL SOURCE AND DESTINATION ARE
SPECIFIED
!
interface Tunnel0
description === Peer device = Branch-2 ===
bandwidth 10000
ip unnumbered Vlan10
ip mtu 1420
ip pim sparse-dense-mode
qos pre-classify
tunnel source ATM1/0
tunnel destination 10.32.150.46
crypto map INT_CM
!
interface Tunnel1
description === Peer device = Branch-1 ===
bandwidth 10000
ip unnumbered Vlan10
ip mtu 1420
ip pim sparse-dense-mode
qos pre-classify
tunnel source ATM1/0
tunnel destination 10.32.153.34
crypto map INT_CM
!
! THIS LOOPBACK INTERFACE ACTS AS THE MULTICAST RP
!
interface Loopback100
ip address 192.168.4.1 255.255.255.255
ip pim sparse-dense-mode
!
! THIS VIF INTERFACE IS USED AS THE MULTICAST SOURCE FOR THE VOICE ENDPOINT
interface Vif1
ip address 192.168.6.1 255.255.255.0
ip pim sparse-dense-mode
!
! NOT USED
!
interface GigabitEthernet0/0
no ip address
shutdown
duplex auto
speed auto
media-type rj45
no negotiation auto
!
! NOT USED
!
interface GigabitEthernet0/1
no ip address
shutdown
duplex auto
speed auto
media-type rj45
no negotiation auto
!
! INTERFACE CONNECTING TO THE PUBLIC NETWORK IN OUR SCENARIO
! ATM PVC 10/100 IS USED IN THIS EXAMPLE. THE PREVIOUSLY DEFINED LLQ QOS POLICY IS USED
HERE
interface ATM1/0
description === Public interface ===
bandwidth 155000