Hoot and Holler over V3PN Configuration Example
Configure
11
OL-6573-01
controller T1 3/1
framing sf
linecode ami
!
! CLASSIFY DIFFERENT QOS TRAFFIC, SETTING IP PRECEDENCE AND DSCP
!
class-map match-all data
match ip precedence 2
class-map match-all control-traffic
match ip dscp af31
class-map match-all video
match ip precedence 4
class-map match-all voice
match ip dscp ef
!
! ALLOCATE AVAILABLE BANDWIDTH FOR EACH QOS CLASSIFICATION, DEPENDING ON EXPECTED NEED
! FOR EXAMPLE, DSCP VALUE EF (CLASS VOICE) WILL BE GIVEN 35% OF THE BANDWIDTH
!
policy-map LLQ
class control-traffic
bandwidth percent 5
class voice
priority percent 35
class video
bandwidth percent 15
class data
bandwidth percent 20
class class-default
fair-queue
!
!
! SET THE IKE POLICY TO USE 3DES
!
crypto isakmp policy 10
encr 3des
authentication pre-share
group 2
crypto isakmp key cisco address 10.32.152.26 no-xauth
!
!
crypto ipsec transform-set TRANSFORM_1 esp-3des esp-sha-hmac
!
! SPECIFY REMOTE PEER
!
crypto map INT_CM 1 ipsec-isakmp
description === Peer device = HUB-R1 ===
set peer 10.32.152.26
set security-association lifetime kilobytes 530000000
set security-association lifetime seconds 14400
set transform-set TRANSFORM_1
match address IPSEC_ACL_1
!
!
! CREATE TUNNEL TO THE HUB ROUTERS. THE MTU IS LOWERED TO ALLOW THE GRE AND IPSEC HEADER
! PIM SD IS ENABLED SO AS TO ALLOW MULTICAST, AND THE TUNNEL SOURCE AND DESTINATION ARE
SPECIFIED
!
!
interface Tunnel0
description === Peer device = HUB-R1 ===
bandwidth 10000
ip unnumbered FastEthernet0/0
ip mtu 1420
ip pim sparse-dense-mode
To Next Page
Loading...
