Cisco 2800 Series - Page 177

Hoot and Holler over V3PN Configuration Example
Verify
37
OL-6573-01
The following is an output example for the show ip ospf neighbor command, performed using the
configuration on the Branch 2 router:
Branch-2# show ip ospf neighbor
Neighbor ID Pri State Dead Time Address Interface
192.168.1.1 0 FULL/ - 00:00:37 192.168.1.1 Tunnel0
The following is an output example for the show ip route command, performed using the configuration
on the Branch 2 router:
Branch-2# show ip route
Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route
Gateway of last resort is 10.32.150.45 to network 0.0.0.0
192.168.4.0/32 is subnetted, 1 subnets
O 192.168.4.1 [110/11] via 192.168.1.1, 00:31:10, Tunnel0
C 192.168.5.0/24 is directly connected, Vif1
10.0.0.0/8 is variably subnetted, 2 subnets, 2 masks
C 10.32.150.44/30 is directly connected, Serial0/0/0
O 192.168.6.0/24 [110/11] via 192.168.1.1, 00:31:10, Tunnel0
O 192.168.7.0/24 [110/21] via 192.168.1.1, 00:31:10, Tunnel0
O 192.168.1.0/24 [110/11] via 192.168.1.1, 00:31:11, Tunnel0
O 192.168.2.0/24 [110/21] via 192.168.1.1, 00:31:11, Tunnel0
C 192.168.3.0/24 is directly connected, FastEthernet0/0
S* 0.0.0.0/0 [1/0] via 10.32.150.45
is directly connected, Serial0/0/0
The following is an output example for the show ip pim neighbor command, performed using the
configuration on the Branch 2 router:
Branch-2# show ip pim neighbor
PIM Neighbor Table
Neighbor Interface Uptime/Expires Ver DR
Address Prio/Mode
192.168.1.1 Tunnel0 00:31:52/00:01:26 v2 1 / S
The following is an output example for the show ip pim rp mapping command, performed using the
configuration on the Branch 2 router:
Branch-2# show ip pim rp mapping
PIM Group-to-RP Mappings
Group(s) 224.0.0.0/4
RP 192.168.4.1 (?), v2v1
Info source: 192.168.4.1 (?), elected via Auto-RP
Uptime: 2d03h, expires: 00:02:47
The following is an output example for the show ip mroute active command, performed using the
configuration on the Branch 2 router:
Branch-2# show ip mroute active
Active IP Multicast Sources - sending >= 4 kbps