Name: Cisco 4400 Series
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

13-12

Cisco Wireless LAN Controller Configuration Guide

OL-17037-01

Chapter 13 Configuring Hybrid REAPWireless Device Access

Configuring Hybrid REAP

Step 2 Click Wireless to open the All APs page (see Figure 13-5).

Figure 13-5 All APs Page

Step 3 Click the name of the desired access point. The All APs > Details (General) page appears (see

Figure 13-6).

Figure 13-6 All APs > Details for (General) Page

Step 4

Choose H-REAP from the AP Mode drop-down box to enable hybrid REAP for this access point.

Note The last parameter on the Inventory tab indicates whether this access point can be configured for

hybrid REAP. Only the 1130AG, 1240AG, and 1250 access points support hybrid REAP.

Step 5 Click Apply to commit your changes and to cause the access point to reboot.

Step 6 Click the H-REAP tab to open the All APs > Details for (H-REAP) page (see Figure 13-7).

Figure 13-7 All APs > Details for (H-REAP) Page

Questions and Answers:

Need help?

Do you have a question about the Cisco 4400 Series and is the answer not in the manual?

Cisco 4400 Series Specifications

General