Cisco 7941G

Configuration referenceDescriptionFeature
For more information, see:
•
Cisco Unified Communications
Manager System Guide, “Cisco
Unified IP Phones” chapter
•
Cisco Unified Communications
Manager Administration Guide,
“Phone Button Template
Configuration” chapter
•
Cisco Unified Communications
Manager Administration Guide,
“Modifying Phone Button Templates”
chapter
The administrator can assign features to line buttons.
Softkeys normally control these features; for example,
New Call, Call Back, End Call, and Forward All. When
the administrator configures these features on the line
buttons, they always remain visible, so users can have a
hard feature key (for example, a hard New Call key).
Programmable line keys
(PLK)
For more information about security, see
Supported Security Features, on page 14.
For additional information, see Cisco
Unified Communications Manager Security
Guide.
Provides a secure (encrypted) connection between two
phones. A security tone plays at the beginning of the call
to indicate that both phones are protected. Some features,
such as conference calling, shared lines, Extension
Mobility, and Join Across Lines are not available when
protected calling is configured. Protected calls are not
authenticated.
Protected Calling
For more information, see:
•
Cisco Unified Communications
Manager System Guide, “Cisco
Unified IP Phones” chapter
•
Cisco Unified Communications
Manager Features and Services
Guide, “Quality Report Tool” chapter
Allows users to use the QRT softkey on a phone to submit
information about problem phone calls. QRT can be
configured for either of two user modes, depending upon
the amount of user interaction desired with QRT.
Quality Reporting Tool
(QRT)
No configuration required.Allows users to call the most recently dialed phone number
by pressing a button.
Redial
To configure the parameter in the Cisco
Unified CM Administration application,
choose Device > Phone, select the
appropriate IP Phones, and scroll to the
Product Specific Configuration Layout pane
(Switch Port Remote Configuration or PC
Port Remote Configuration).
To configure the setting on multiple phones
simultaneously, configure the Remote Port
Configuration in the Enterprise Phone
Configuration (System > Enterprise Phone
Configuration).
Allows the administrator to configure the speed and duplex
function of the phone Ethernet ports remotely by using
Cisco Unified CM Administration. This enhances the
performance for large deployments with specific port
settings.
If the ports are configured for Remote Port
Configuration in Cisco Unified CM, the data
cannot be changed on the phone.
Note
Remote Port Configuration
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
137
Features, Templates, Services, and Users
Telephony Features Available for Cisco Unified IP Phone