EasyManuals Logo

Cisco 7941G Administration Guide

Cisco 7941G
292 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #225 background imageLoading...
Page #225 background image
DescriptionItem
Internal time stamp indication when the last RTCP Sender Report was sent.Sender Report Time Sent
(see note)
Total number of RTP data packets that have been lost since starting receiving
data on this connection. Defined as the number of expected packets less the
number of packets actually received, where the number of received packets
includes any that are late or duplicate. The value displays as 0 if the
connection was set to send-only mode.
Rcvr Lost Packets
Estimate of mean deviation of the RTP data packet interarrival time, measured
in milliseconds. The value displays as 0 if the connection was set to send-only
mode.
Avg Jitter
Type of audio encoding used for the received stream.Rcvr Codec
Number of times the RTCP Receiver Reports have been sent.Rcvr Reports Sent
(see note)
Internal time stamp indication when a RTCP Receiver Report was sent.Rcvr Report Time Sent
(see note)
Total number of RTP data packets received by the phone since starting
receiving data on this connection. Includes packets received from different
sources if this is a multicast call. The value displays as 0 if the connection
was set to send-only mode.
Rcvr Packets
Total number of payload octets received in RTP data packets by the device
since starting reception on the connection. Includes packets received from
different sources if this is a multicast call. The value displays as 0 if the
connection was set to send-only mode.
Rcvr Octets
Score that is an objective estimate of the mean opinion score (MOS) for
listening quality (LQK) that rates from 5 (excellent) to 1 (bad). This score is
based on audible concealment events due to frame loss in the preceding
8-second interval of the voice stream. For more information, see Voice Quality
Monitoring, on page 232.
The MOS LQK score can vary based on the type of codec that the
Cisco Unified IP Phone uses.
Note
MOS LQK
Average MOS LQK score observed for the entire voice stream.Avg MOS LQK
Lowest MOS LQK score observed from start of the voice stream.Min MOS LQK
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
205
Remote Monitoring
Streaming Statistics

Table of Contents

Other manuals for Cisco 7941G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 7941G and is the answer not in the manual?

Cisco 7941G Specifications

General IconGeneral
Keypad number of keys12
Touchscreen-
Display resolution320 x 222 pixels
SpeakerphoneYes
Voice codecsG.729a
BluetoothNo
Supported network protocolsDHCP, TFTP, SCCP, DSCP
Ethernet LAN (RJ-45) ports2
Input voltage48 V
Dimensions (WxDxH)266.7 x 152.4 x 203.2 mm
Storage temperature (T-T)-10 - 60 °C
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)10 - 95 %
Handset typeWired handset
Product typeIP Phone
Product colorGray
Safety(UL) 60950, (CSA) C22.2 No. 60950, IEC 60950, EN 60950, AS/NZS 60950
CertificationCE (FCC) 15 (CFR 47) B ICES-003 B EN55022 B CISPR22 B AS/NZ 3548 B VCCI B EN55024 EN 50082-1 EN 61000-3-2 EN 61000-3-3
Compliance industry standardsIEEE 802.3, IEEE 802.3u, IEEE 802.1Q, IEEE 802.3af
Lines quantity- lines
Phonebook capacity- entries
Number of handles included1 pc(s)
Weight and Dimensions IconWeight and Dimensions
Weight1600 g

Related product manuals