EasyManuals Logo

Cisco 7941G Administration Guide

Cisco 7941G
292 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #226 background imageLoading...
Page #226 background image
DescriptionItem
Baseline or highest MOS LQK score observed from start of the voice stream.
These codecs on the Cisco Unified IP Phones 7962G and 7942G provide the
following maximum MOS LQK score under normal conditions with no frame
loss:
G.711 gives 4.5
G.722 gives 4.5
G.728/iLBC gives 3.9
G.729 A/AB gives 3.8
These codecs on the Cisco Unified IP Phones 7961G/G-GE and
7941G/41G-GE provide the following maximum MOS LQK score under
normal conditions with no frame loss:
G.711 gives 4.5
G.729 A /AB gives 3.7
Max MOS LQK
Version of the Cisco proprietary algorithm used to calculate MOS LQK
scores.
MOS LQK Version
Total number of concealment frames divided by total number of speech
frames received from start of the voice stream.
Cumulative Conceal Ratio
Ratio of concealment frames to speech frames in preceding 3-second interval
of active speech. If using voice activity detection (VAD), a longer interval
might be required to accumulate 3 seconds of active speech.
Interval Conceal Ratio
Highest interval concealment ratio from start of the voice stream.Max Conceal Ratio
Number of seconds that have concealment events (lost frames) from the start
of the voice stream (includes severely concealed seconds).
Conceal Secs
Number of seconds that have more than 5 percent concealment events (lost
frames) from the start of the voice stream.
Severely Conceal Secs
Estimate of the network latency, expressed in milliseconds. Represents a
running average of the round-trip delay, measured when RTCP receiver report
blocks are received.
Latency
(see note)
Maximum value of instantaneous jitter, in milliseconds.Max Jitter
RTP packet size, in milliseconds, for the transmitted stream.Sender Size
Number of times RTCP Sender Reports have been received.Sender Reports Received
(see note)
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco
Unified Communications Manager 9.0 (SCCP and SIP)
206
Remote Monitoring
Streaming Statistics

Table of Contents

Other manuals for Cisco 7941G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 7941G and is the answer not in the manual?

Cisco 7941G Specifications

General IconGeneral
Keypad number of keys12
Touchscreen-
Display resolution320 x 222 pixels
SpeakerphoneYes
Voice codecsG.729a
BluetoothNo
Supported network protocolsDHCP, TFTP, SCCP, DSCP
Ethernet LAN (RJ-45) ports2
Input voltage48 V
Dimensions (WxDxH)266.7 x 152.4 x 203.2 mm
Storage temperature (T-T)-10 - 60 °C
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)10 - 95 %
Handset typeWired handset
Product typeIP Phone
Product colorGray
Safety(UL) 60950, (CSA) C22.2 No. 60950, IEC 60950, EN 60950, AS/NZS 60950
CertificationCE (FCC) 15 (CFR 47) B ICES-003 B EN55022 B CISPR22 B AS/NZ 3548 B VCCI B EN55024 EN 50082-1 EN 61000-3-2 EN 61000-3-3
Compliance industry standardsIEEE 802.3, IEEE 802.3u, IEEE 802.1Q, IEEE 802.3af
Lines quantity- lines
Phonebook capacity- entries
Number of handles included1 pc(s)
Weight and Dimensions IconWeight and Dimensions
Weight1600 g

Related product manuals