To ChangeDescriptionOption
Set Admin VLAN ID Field, on
page 76
Auxiliary VLAN in which the phone is a
member.
Used only if the phone does not receive an
auxiliary VLAN from the switch; otherwise it
is ignored.
Admin. VLAN ID
Set SW Port Configuration Field,
on page 76
Speed and duplex of the network port. Valid
values:
•
autonegotiate
• 10 Half—10-BaseT/half duplex
• 10 Full—10-BaseT/full duplex
• 100 Half—100-BaseT/half duplex
• 100 Full—100-BaseT/full duplex
• 1000 Full—1000-BaseT/full duplex
If the phone is connected to a switch, configure
the port on the switch to the same speed/duplex
as the phone, or configure both to
auto-negotiate.
If you change the setting of this option, you
must change the PC Port Configuration option
to the same setting.
SW Port Configuration
Set PC Port Configuration Field,
on page 76
Speed and duplex of the access port. Valid
values:
•
autonegotiate
• 10 Half—10-BaseT/half duplex
• 10 Full—10-BaseT/full duplex
• 100 Half—100-BaseT/half duplex
• 100 Full—100-BaseT/full duplex
• 1000 Full—1000-BaseT/full duplex
If the phone is connected to a switch, configure
the port on the switch to the same speed/duplex
as the phone, or configure both to
auto-negotiate.
If you change the setting of this option, you
must change the SW Port Configuration option
to the same setting.
PC Port Configuration
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco
Unified Communications Manager 9.0 (SCCP and SIP)
66
Cisco Unified IP Phone Settings
Network Configuration Menu