Cisco 8800 Series - EAP and User Database Compatibility; Power Management

Cisco IP Phone 8800 Series Wireless LAN Deployment Guide
20
The Cisco IP Phone 8800 Series supports 802.11r (FT) with WPA2-PSK or WPA2 and CCKM with WPA2 or WPA.
FSR Type
Authentication
Key Management
Encryption
802.11r (FT)
PSK
WPA2
AES, TKIP
802.11r (FT)
EAP-FAST
WPA2
AES, TKIP
802.11r (FT)
PEAP-MSCHAPv2
WPA2
AES, TKIP
CCKM
EAP-FAST
WPA2, WPA
AES, TKIP
CCKM
PEAP-MSCHAPv2
WPA2, WPA
AES, TKIP
EAP and User Database Compatibility
The following chart displays the EAP and database configurations supported by the Cisco IP Phone 8861.
Database Type
EAP-FAST
(Phase Zero)
PEAP-
MSCHAPv2
Cisco ACS
Yes
Yes
Windows SAM
Yes
Yes
Windows AD
Yes
Yes
LDAP
No
No
ODBC
(ACS for Windows Only)
Yes
Yes
LEAP Proxy RADIUS
Server
Yes
Yes
All Token Servers
No
No
Power Management
The power supply (CP-PWR-CUBE-4=) is required to enable the Cisco IP Phone 8861 for wireless LAN mode, as there is no
internal battery.
Wireless LAN is automatically disabled temporarily when Ethernet is connected to the Cisco IP Phone 8861, but will be
automatically re-enabled once Ethernet is disconnected if Wireless LAN was enabled previously.
The Cisco IP Phone 8861 primarily uses active mode (no Wi-Fi power save) when in idle or on call.
Null Power Save (PS-NULL) frames are utilized for off-channel scanning.