Cisco 8800 Series - Configuring the Cisco Unified Wireless LAN Controller and Access Points

Cisco IP Phone 8800 Series Wireless LAN Deployment Guide
51
For more information on these features, see the Cisco IP Phone 8800 Series Administration Guide or the Cisco IP Phone 8800
Series Release Notes.
http://www.cisco.com/c/en/us/support/collaboration-endpoints/unified-ip-phone-8800-series/products-maintenance-guides-
list.html
http://www.cisco.com/c/en/us/support/collaboration-endpoints/unified-ip-phone-8800-series/products-release-notes-list.html
Configuring the Cisco Unified Wireless LAN Controller and Access
Points
When configuring the Cisco Unified Wireless LAN Controller and Access Points, use the following guidelines:
• Ensure 802.11r (FT) or CCKM is Enabled
• Set Quality of Service (QoS) to Platinum
• Set the WMM Policy to Required
• Ensure Session Timeout is enabled and configured correctly
• Ensure Aironet IE is Enabled
• Set DTPC Support to Enabled
• Disable P2P (Peer to Peer) Blocking Action / Public Secure Packet Forwarding (PSPF)
• Ensure Client Exclusion is configured correctly
• Disable DHCP Address Assignment Required
• Set MFP Client Protection to Optional or Disabled
• Set the DTIM Period to 2
• Set Client Load Balancing to Disabled
• Set Client Band Select to Disabled
• Set IGMP Snooping to Enabled
• Enable Symmetric Mobile Tunneling Mode if Layer 3 mobility is utilized
• Enable Short Preamble if using 2.4 GHz
• Enable ClientLink if utilizing Cisco 802.11n/ac Access Points
• Configure the Data Rates as necessary
• Enable CCX Location Measurement
• Configure Auto RF as necessary
• Set Admission Control Mandatory to Enabled for Voice
• Set Load Based CAC to Enabled for Voice
• Enable Traffic Stream Metrics for Voice
• Set Admission Control Mandatory to Disabled for Video
• Set EDCA Profile to Voice Optimized or Voice and Video Optimized
• Set Enable Low Latency MAC to Disabled
Line/Button configured will be display on one KEM.