Cisco 8800 Series - AP Groups

Cisco IP Phone 8800 Series Wireless LAN Deployment Guide
72
AP Groups
AP Groups can be created to specify which WLANs / SSIDs are to be enabled and which interface they should be mapped to as
well as what RF Profile parameters should be used for the access points assigned to the AP Group.
On the WLANs tab, select the desired SSIDs and interfaces to map to then select Add.
On the RF Profile tab, select the desired 802.11a or 802.11b RF Profile, then select Apply.
If changes are made after access points have joined the AP Group, then those access points will reboot once those changes are
made.
On the APs tab, select the desired access points then select Add APs.
Those access points will then reboot.