• The call will then be directed to the Cisco IP Phone 8861 via the Bluetooth enabled mobile phone.
• Select Move audio to switch the call back to the Bluetooth enabled mobile phone.
Upgrading Firmware
To upgrade the firmware, install the signed COP file for Cisco Unified Communications Manager.
For information on how to install the COP file, refer to the Cisco Unified Communications Manager Operating System
Administrator Guide at this URL:
http://www.cisco.com/c/en/us/support/unified-communications/unified-communications-manager-callmanager/products-
maintenance-guides-list.html
During TFTP/HTTP server download, the configuration file is parsed and the device load is identified. The Cisco IP Phone
8800 Series then downloads the firmware files to flash if it is not running the specified image already.
The Load Server can be specified as an alternate TFTP server to retrieve firmware files, which is located in the product specific
configuration section of Cisco IP Phone 8800 Series within Cisco Unified Communications Manager Administration.
To Next Page
Loading...
Need help?
General
