Configuring QoS Policies for the Network
Set up QoS policies and settings for the following network devices.
Configuring Cisco Switch Ports
Configure the Cisco Unified Wireless LAN Controller and Cisco Access Point switch ports as well as any uplink switch ports.
Configure the Cisco Unified Wireless LAN Controller for trust COS.
Below is a sample switch configuration for the Cisco Unified Wireless LAN controller:
mls qos
!
interface X
mls qos trust cos
Configure the Cisco Access Point switch ports as well as any uplink switch ports for trust DSCP.
Below is a sample switch configuration for an access point:
mls qos
!
interface X
mls qos trust dscp
Note: When using the Cisco Unified Wireless LAN Controller, DSCP trust must be implemented or trust the UDP data ports
used by the Cisco Unified Wireless LAN Controller (CAPWAP = 5246 and 5247) on all interfaces where wireless packets will
traverse to ensure QoS markings are correctly set.
To Next Page
Loading...
Need help?
General
