Flinders
Connecting
CRICOS No. 00114A
Camera Lens Shutter
The camera lens shutter allows you to physically block video transmission from your
camera.
Close Camera Lens Shutter
The following figure shows the location of the camera lens shutter.
Procedure
Step 1 To close the shutter, rotate the lens clockwise.
Step 2 To open the shutter, rotate the lens counterclockwise.
Video Camera Installation
The Video Camera can be mounted on your IP Phone or it can be mounted on your
computer monitor. To obtain the best user experience for video calls, we recommend
leaving the camera mounted on your phone.
If you need help installing or positioning your camera, contact the ITS Service Desk
on 12345.
Mount Camera on Phone
Step 1 Remove the protective plastic from the camera lens and body.
Step 2 On the phone, remove the small plastic cover located on the topside of the
phone display.
Step 3 With your phone idle (no calls), slide the camera USB connector (on the
bottom of the camera) into the Phone USB port (on the back of the phone display).
As you do this, pins on the underside of the camera fit into pinholes on the top of the
phone display to further stabilize the camera.
To Next Page
Loading...
