Cisco 9971 - Page 41

Flinders
Connecting
CRICOS No. 00114A
Calls, or, press the Primary line key if it is set up by your administrator to display all
calls.
Q. How do I check missed calls on my phone?
A. To check missed calls on your phone, perform the following actions:
• Press Applications, select Call History, and press Missed.
• Press Missed Calls.
Q. How do I exit from a running application?
A. To exit from a running applications you must:
1.
Press Applications .
2.
Use the Navigation pad and Select button to scroll and select Running
Applications.
3.
Select a running application and press Close App to close the application.
When prompted, save your changes.
4.
Press Exit end the running application.
If you do not exit a running application, it continues to run in the background.
Q. What does the Swap softkey do?
A. The Swap softkey allows you to toggle between two calls before completing the
transfer or creating a conference. This allows you to consult privately with the party
or parties on each call before combining the calls into a conference.
Q. Not all calls present video on my phone. Why not?
A. To see an image of the other party on your phone screen, the other party’s phone
must support video and the other party must have a camera installed and enabled on
the phone. During conference calls, the conference system used during the call must
support video conferencing.
Q. What does the Preview softkey do?
A. If you have a Cisco Unified Video Camera installed on your phone, you can press
Preview to see the view from your camera when you are not in a video call. Try
using Preview before making video calls to help set up and position your camera
effectively.
Q. What happens to video when I put a call on hold?
A. Video transmission is muted (blocked) until you resume the call.
Q. What do the different light colors on my Cisco Unified Video Camera indicate?
A. The colors indicate video transmission states as follows:
• Green: Your video is transmitting.
• Red: Your video is muted.
Q. How can I close the shutter on my Cisco Unified Video Camera?
A. Close the camera shutter by rotating the camera lens clockwise. Rotate counter-
clockwise to open the shutter again.