Cisco Aironet 1100 Series User Manual

10-9
Cisco Aironet 1100 Series Access Point Installation and Configuration Guide
OL-2851-01
Chapter 10 Configuring Authentication Types
Matching Access Point and Client Device Authentication Types
Use the no form of these commands to reset the values to default settings.
Matching Access Point and Client Device Authentication Types
To use the authentication types described in this section, the access point authentication settings must
match the authentication settings on the client adapters that associate to the access point. Refer to the
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows for
instructions on setting authentication types on wireless client adapters. Refer to Chapter 9, “Configuring
WEP and WEP Features,” for instructions on configuring WEP on the access point.
Table 10-2 lists the client and access point settings required for each authentication type.
Step 5
dot1x reauth-period seconds
[server]
Enter the interval in seconds that the access point waits before
forcing an authenticated client to reauthenticate.
• (Optional) Enter the server keyword to configure the
access point to use the rauthentication period specified by
the authentication server. If you use this option, configure
your authentication server with RADIUS attribute 27,
Session-Timeout. This attribute sets the maximum number
of seconds of service to be provided to the client before
termination of the session or prompt. The server sends this
attribute to the access point when a client device performs
EAP authentication.
Step 6
end Return to privileged EXEC mode.
Step 7
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Table 10-2 Client and Access Point Security Settings
Security Feature Client Setting Access Point Setting
Static WEP with open
authentication
Create a WEP key and enable Use
Static WEP Keys and Open
Authentication
Set up and enable WEP and enable
Open Authentication
Static WEP with shared key
authentication
Create a WEP key and enable Use
Static WEP Keys and Shared Key
Authentication
Set up and enable WEP and enable
Shared Key Authentication
LEAP authentication Enable LEAP Set up and enable WEP and enable
EAP and Open authentication

Cisco Aironet 1100 Series Specifications

General

Brand	Cisco
Model	Aironet 1100 Series
Category	Wireless Access Point
Language	English