Cisco Aironet 1100 Series - Using the Cable Lock Feature

D-9
Cisco Aironet 1100 Series Access Point Installation and Configuration Guide
OL-2851-01
Appendix D Mounting Instructions
Using the Cable Lock Feature
Using the Cable Lock Feature
When you mount the access point using the cubical partition mount or desktop holster, you can secure
the access point with your own security cable. Follow these steps to install the security cable.
Note Cisco recommends using a Kensington Notebook Microstar (model number 64068) to secure your access
point.
Step 1 Loop the security cable around a nearby immovable object.
Step 2 Insert the key into the lock.
Step 3 Insert the lock into the security slot on the access point.
Step 4 Rotate the key right or left to secure the lock to the access point.
Step 5 Remove the key.
A properly secured lock and cable look similar to Figure D-8.
Figure D-8 Kensington Lock
81175