Cisco Aironet 1100 Series - Extracting a Tar File

19-7
Cisco Aironet 1100 Series Access Point Installation and Configuration Guide
OL-2851-01
Chapter 19 Managing Firmware and Configurations
Working with the Flash File System
For source-url, specify the source URL alias for the local or network file system. These options are
supported:
• For the local Flash file system, the syntax is
flash:
• For the File Transfer Protocol (FTP), the syntax is
ftp:[[//username[:password]@location]/directory]/tar-filename.tar
• For the Remote Copy Protocol (RCP), the syntax is
rcp:[[//username@location]/directory]/tar-filename.tar
• For the Trivial File Transfer Protocol (TFTP), the syntax is
tftp:[[//location]/directory]/tar-filename.tar
The tar-filename.tar is the tar file to display.
You can also limit the display of the files by specifying an optional list of files or directories after the tar
file; then only these files are displayed. If none are specified, all files and directories are displayed.
This example shows how to display the contents of the c3550-i5q3l2-mz.121-6.EA1.tar file that is in
Flash memory:
ap# archive tar /table flash:c3550-i5q3l2-mz.121-6.EA1.tar
info (219 bytes)
c3550-i5q3l2-mz.121-6.EA1/ (directory)
c3550-i5q3l2-mz.121-6.EA1/html/ (directory)
c3550-i5q3l2-mz.121-6.EA1/html/foo.html (0 bytes)
c3550-i5q3l2-mz.121-6.EA1/c3550-i5q3l2-mz.121-6.EA1.bin (610856 bytes)
c3550-i5q3l2-mz.121-6.EA1/info (219 bytes)
info.ver (219 bytes)
This example shows how to display only the c3550-i5q3l2-mz.121-6.EA1/html directory and its contents:
ap# archive tar /table flash:c3550-tv0-m.tar c3550-i5q3l2-mz.121-6.EA1/html
c3550-i5q3l2-mz.121-6.EA1/html/ (directory)
c3550-i5q3l2-mz.121-6.EA1/html/foo.html (0 bytes)
Extracting a tar File
To extract a tar file into a directory on the Flash file system, use this privileged EXEC command:
archive tar /xtract source-url flash:/file-url
For source-url, specify the source URL alias for the local or network file system. These options are
supported:
• For the local Flash file system, the syntax is
flash:
• For the File Transfer Protocol (FTP), the syntax is
ftp:[[//username[:password]@location]/directory]/tar-filename.tar
• For the Remote Copy Protocol (RCP), the syntax is
rcp:[[//username@location]/directory]/tar-filename.tar
• For the Trivial File Transfer Protocol (TFTP), the syntax is
tftp:[[//location]/directory]/tar-filename.tar
The tar-filename.tar is the tar file from which to extract files.
For flash:/file-url, specify the location on the local Flash file system into which the tar file is extracted.
You can also specify an optional list of files or directories within the tar file for extraction. If none are
specified, all files and directories are extracted.