Cisco Aironet 1100 Series - Disabling and Enabling CDP

16-3
Cisco Aironet 1100 Series Access Point Installation and Configuration Guide
OL-2851-01
Chapter 16 Configuring CDP
Configuring CDP
Use the no form of the CDP commands to return to the default settings.
This example shows how to configure and verify CDP characteristics:
AP# configure terminal
AP(config)# cdp holdtime 120
AP(config)# cdp timer 50
AP(config)# end
AP# show cdp
Global CDP information:
Sending a holdtime value of 120 seconds
Sending CDP packets every 50 seconds
For additional CDP show commands, see the “Monitoring and Maintaining CDP” section on page 16-4.
Disabling and Enabling CDP
CDP is enabled by default. Beginning in Priveleged Exec mode, follow these steps to disable the CDP
device discovery capability.
Beginning in privileged EXEC mode, follow these steps to enable CDP when it has been disabled:
This example shows how to enable CDP if it has been disabled.
AP# configure terminal
AP(config)# cdp run
AP(config)# end
Step 3
cdp timer seconds (Optional) Set the transmission frequency of CDP updates in
seconds.
The range is from 5 to 254; the default is 60 seconds.
Step 4
end Return to Privileged Exec mode.
Command Purpose
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
no cdp run Disable CDP.
Step 3
end Return to Privileged Exec mode.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
cdp run Enable CDP after disabling it.
Step 3
end Return to privileged EXEC mode.